Temperature Transducer in room housing, with display, with changeover contact, Modbus RTU

SKU: FS1080

Category: Room

Manufacturers: FuehlerSysteme

0...+50°C
Modbus RTU, relay
DIP-switch-technology
optional with LCD-Display
protection type IP30

Output: Modbus RTU
Equipment: without

Display

Display, Relay

Relay
Temperature: 0...+50°C

Available immediately

from 119,49 €

excl. 19% VAT , plus

This item has variations. Please select the requested variation.

The FS1080 temperature transducer in modern room design registers the temperature via the sensor in the housing and converts this measured value into a digital output signal. The room temperature transducer is, for example in offices or flats, fitted onto the wall or on the flush-mounted socket. In the event of a deviation from the reference temperature the service correction can be performed directly on the device. As special equipment a potential-free alternating contact and/or a backlit display are available The contents of the display can be rotated in steps of 90° by using a command. As special functions a series of defined measured values from other bus-participants (also cross-manufacturers) can be shown in the display. To display measured values from other bus-participants these are entered into the corresponding register by the bus-Master. The optional alternating contact can be configurated for measured values from other bus-participants. The configuration of address, transmission mode/speed, terminating resistor and master/slave function of the bus-devices can easily be done using the innovative DIP switch technology. Thus devices can quickly and easily integrated into the system and later parameterised via the master. The bus-devices can even be reset to the works settings during operation of the master. Thus the basic functionality of the device is recreated in a matter of seconds. This can be necessary in the event of incorrect parameterisations of, e.g. offset, switching threshold, display modes etc.. By means of the FS master/slave topology autarkic nodes without additional SPS master can be installed within the device series. Hereby a bus-device assumes the master function in the node. This requests the measured values from other bus-participants, automatically enters these into the corresponding register and shows them in the internal display. Furthermore the master can evaluate and operate additional actuators in the device series (analogue in- and outputs, relay station).

Measurement range temp.:	0...+50°C
Accuracy:	±0,2 K + max. ±1% mv (-30?+100°C), else ±0,3 K + max. ±1,5% mv
Supply voltage:	24 V DC (±5%)
Current consumption:	max. 20 mA + 30 mA (option display) + 20 mA (option relay)
Alarm output:	1 x potential-free change-over contact, 48 V, 1 A
Digital output:	Modbus RTU
Switching Hysteresis Relay:	can be entered in the register
Offset:	can be entered in the register
Electrical connection:	push-in terminal, no tools required, time-saving
Display:	optional LCD display with backlight on/off/auto
Cable gland:	on the back or housing side (predetermined breaking point)
Housing:	ABS polyman, colour signal white like RAL 9003
Dimensions:	Housing: L 82 x W 82 x H 25 mm
Protection type:	IP30, IP20 (with display)
Protection class:	III
Working range r.H.:	0...98% r.H. in contaminant-free, non-condensing air
Working temperature:	Electronic: -20...+70°C
Storage temperature:	-20...+70°C
Installation:	on-wall or on flush-mounted box
Approvals:	CE, EAC, RoHS