Signal Converter I/O - Modbus In / 8 Analog Out for top hat rail mounting, Modbus RTU, 0-10 V or 4-20 mA

SKU: FS1702

Category: Signal Cconverter

Manufacturers: FuehlerSysteme

8 analog outputs (4-20 mA or 0-10 V)
input Modbus-RTU
DIN rail mounting
parameterization via DIP switch
optional Bus connector

Output: 8 x 0-10 V

8 x 4-20 mA
Input: Modbus RTU

Available immediately

323,47 €

excl. 19% VAT , plus

This item has variations. Please select the requested variation.

The I/O-signal converters convert measured values from Modbus devices to analog standard signals (voltage or current). The modules can process up to 8 outputs (4-20mA or 0-10 V) simultaneously and can be controlled via the Modbus-RTU protocol. With this e.g. existing systems with analog field devices can be controlled using modern digital technology and cabling costs can be reduced. The I/O-signal converters can either be coupled as Modbus slaves to any Modbus master, or they can take over the function of a Modbus master. Addressing and parameterization can be carried out very easily using the DIP switches accessible from the front. The high-quality DIN rail housings are equipped with color-coded push-in terminals to enable quick wiring. Optionally, the DIN rail housings can be upgraded with bus connectors for efficient module communication. The supply and Modbus cabling of the I/O-signal converters can thus be considerably simplified. For a higher transmission speed, the I/O-signal converters are also equipped with the block formation function.

Supply voltage	24 V DC
Input	Modbus RTU
Output	Version voltage - 8x 0-10 V DC, configurable or, version current 8x 4-20 mA DC, configurable
Resolution	10 BIT
Accuracy	version voltage +/- 20 mV, version current +/- 40 µA
Input resistance	voltage version min. 10kOhm; current version max. 250 ohm
Current consumption	voltage version max. 50 mA; current version max. 50 mA + max. 20mA/channenl
Assembly	mounting for DIN rails
Plug-in terminals	(blocks of 4) with spring tension, locking of the plug-in terminals, color coding of the terminals, wire diameter max. 1.5 mm²
Pull-up resistors	switchable via on-board DIP switch
Configuration address, modes	via DIP switch onboard
Operating temperature	0… 50 ° C, max. 90% r.H.
Housing	approx. D 100 x W 19 x H 125 mm
Protection class	IP 20
Optional	DIN rail-eNET-system connector (2 required)
Approvals	CE, EAC, RoHs

Bedienungsanleitung / Operating Manual - FS1702

Bedienungsanleitung / Operating Manual - FS1702

Modbus RTU Systembeschreibung und Konfiguration

Modbus RTU Systembeschreibung und Konfiguration