Brightness/Motion Transducer for surface mounting, with changeover contact, 0-10 V

SKU: BHA/A-UR

Discount group: 2

Category: On-Wall

Manufacturers: FuehlerSysteme

motion yes/no
4 measurement ranges
0-0,5 / 0-1 / 0-20 / 0-50 kLux
0-10 V, change-over contact
selectable mode brightness-dependent movement detection
protection type IP65
hinge lock technology

Delivery time: 11 - 12 Workdays (DE - int. shipments may differ)

180,09 €

excl. 19% VAT , plus

Zubehör zum Mitbestellen:

1x Snap-on mounting for DIN rails + 7,50 €

The motion and brightness sensor BHA/A registers movements over a scope of 360° with a coverage of approx.10 m and, in addition, the brightness 0-50 kLux using an infrared sensor/photo-diode. 4 different measuring ranges for the brightness measurement can be selected (0-0.5 kLux, 0-1 kLux, 0-20 kLux, 0-50 kLux) which can be switched, according to requirements, by the innovative DIP switching technology. In the event of movement a relay contact, whose retention time can be switched freely between 5 second and 15 minutes using a 270° potentiometer, is switched. The transducer converts the brightness measured into a linear output signal 0-10 V. Alternatively a setting can be made on the device so that the motion detection is done depending on the measured brightness (light guided motion detection). The desired light threshold is at any value using an offset controller, The robust housing is defined especially for outdoor use. The motion and brightness sensor is optimally suited for control processes, such as e.g. temperature or light control in offices.

Measuring principle:	alteration of position from persons and subjects with an temperature difference of > 3 K to the sensor
Measurement range motion:	motion yes/no, apex angle 90°/110° on 360° range, reach 10 m
Measurement range brightness:	0-0,5 kLux, 0-1 kLux, 0-20 kLux, 0-50 kLux
Accuracy:	±10% FS (20°C)
Temperature dependency:	±5% FS / 10 K
Linearity inaccuracy:	< ±5% final value
Sensor:	Motion: infrared sensor, Brightness: photodiode
Response time (t90):	< 1 s
Sensor protection:	mounted inside housing
Supply voltage:	24 V AC/DC (±5%)
Current consumption:	typ. 25 mA at 24 V DC
Analogue output 0-10 V:	3-wire connection
Alarm output:	1 x potential-free change-over contact, 48 V, 1 A
Threshold:	threshold for brightness-dependent motion detection adjustable by 270° potentiometer
Offset:	±10% from the selected measuring range by 270° potentiometer
Electrical connection:	screw terminals max. 1,5 mm²
Running-in time:	< 3 s
Holding time:	adjustable from 5 sec. up to 15 min. by 270° potentiometer
Cable gland:	PG11 high-strength cable gland with strain relief
Housing:	Polycarbonate PC UL 94 V0 with hinge locks, color signal white similar to RAL 9003
Dimensions:	Housing: L 89 x W 80 x H 47 mm
Protection type:	IP65
Protection class:	III
Working range r.H.:	0...98% r.H. in contaminant-free, non-condensing air
Working temperature:	-20...+50°C
Storage temperature:	-20...+50°C
Installation:	screw fastening
Approvals:	CE, EAC, RoHS